Highlights

品牌：BUBBLESCUBA

产地：中国

吊牌价：150

上市时间：2015年春季

Description

bubblescuba.com.cn

nn

未经本店同意，盗用本店图片一律淘宝举报

nn

BCD工具 充气管阀头拆卸维修K型阀,潜水背飞夹克

nn

nn

Inflator Service Tool with O-Ring Kit
n
nThis stainless steel Inflator Service Tool has three openings that allow easy disassembly of the most widely used tek power inflator found on
n
nDive Rite, Hollis, Light Monkey, Halcyon, OMS, OxyCheq and many other brands. With our tool we also include a complete set of replacement Viton O-rings for the inflator.
n
n 1/2 hex wrench for the low pressure quick release nipple
n Special spanner with two bent tangs which fit the slots in the inlet valve cartridge assembly and facilitates its easy removal
n 1/4 hex to keep the end of the valve spool in place while removing the plastic button from the cartridge valve assembly
n Includes the five Viton O-rings found in the power inflation mechanism: 112-V90B, 012-V90B, 011-V90B, and two 006-V75B.
n Now includes a free slotted nut driver used to service scuba valves.
n
n

nn

How to Overhaul a Power Inflator

nn

n

nn

If the base of the inflator QD fitting is leaking, use the 1/2 hex to remove the fitting and replace the o-ring. However, look closely if you see a leak.

nn

Sometimes the leak is not coming from the base of the fitting, but rather from the connection to the hose. There is a small o-ring in the female end of the hose fitting that is more frequently the source of the leak.

nn

If the inflator is dribbling gas into the BC, you will have to completely overhaul the inflator.

nn

Start by mating the spanner tangs to the two slots of the inlet valve cartridge assembly, then unscrew counter clockwise until the entire assembly can be removed.

nn

Now disassemble the cartridge assembly. Use the 1/4 hex to keep the end of the spool from turning while you unscrew the plastic button.

nn

Once the button separates from the spool, push the spool out from cartridge barrel.

nn

Remove all the o-rings (noting their relative positions and sizes) and clean everything, including the inside of the barrel and the plastic body of the inflator,by soaking in white vinegar and water. If need be, scrub with a light application of a toothbrush.

nn

Replace the o-rings and reassemble. The o-rings must be clean and need not be lubricated.

nn

Some people lubricate the small 006 o-rings to provide a smoother operating feel, but we observe they are not lubricated at the factory in new inflators.

nn

(We do not lubricate because we think it attracts dirt and just gums up the works so that it has to be more frequently cleaned.)

nn

Tighten until snug, but do not over tighten or you will crack the plastic body. If the inflator still leaks or begins to leak within a few dives,then the surfaces which the o-rings seal against are worn and the entire inflator assembly should be replaced.

nn

A few words of caution: This service kit is a great save-a-dive solution but our recommendation is to replace, not service, your power inflator if it develops any problems.

nn

Improper service could cause a failure of buoyancy control, which has serious and life threatening consequences.

nnnn"